About us Offer Transport service Certificates Contact
      Electric heating elements type GT     Electric heating elements     Steel heaters     Electric heating elements type EG

Electric heating elements

The MEK type is intended for heating different systems, ranging from smaller onces, such as tube registers or towel dryers up to radiators in the central heating systems. It was designed in such way as to be easily installes into all types of tubes, cast, steel and aluminium radiators.

APPLIANCE
The MEK type is intended for heating different systems, ranging from smaller once, such as tube registers or towel warmers up to radiators in the central heating systems. It is designed in order to be easily installed into all types of tubes, cast, steel and aluminium radiators

ADVANTAGES OF MEK
The advantages of MEK over other alternative sources of heating:

  • it is fireproof (carpet, curtain)
  • there is no danger of direct contact to heated wire under voltage with metal objects
  • there is no combustion of particles of dust on heating surface
  • it is not necessary to have an extra room for it
  • regulation possibility of heating intensity (as a protection of freezing) in rooms that are used periodically (e.g.weekend cottages)
  • in case of economic storey heating (i.c. heating of single room)
  • cost-effective, it is cheeper than any other heating source

The MEK type appliance is made out of the highest - quality, atested raw materials and components, providing the warranty for perfect functioning.

The work of the MEK type appliance is based on "thermosiphonic effect", with the electric heater 1 playing the role of "thermodynamic pump". The heating body operates as an uniform system, individual parts (components) of which completly and evenly "heat", owing to the water circulation induced by "thermosiphonic effect". The button 2 in the electronic thermoregulator enables refine regulation of the ambient temperature. As s protection of the possible overheating, thermic fuses have been installed, which melt at an increased temperature and disconnect the feed circuit of the heater. The light of the signal lamp 3 (installed inside the cap) indicates that the heater works.

The Mek appliance was designed in such a way that it can be installed easily without help of an expert. Detailed instruction for installation is enclosed with each appliance.

 
Description MEK
03 06 09 10 12 15 20
Electrical connector 230 V ~ 50Hz
Heater power (W) 300 600 900 1000 1200 1500 2000
Temperature regulation 5-70°C +/- 3°C
Connecting cable 1.8m PP/J-Y 3 x 0,75 PP/J-Y 3 x 1
Melting temp of the fuse 99 °C
Isolation class l
IP protection 44
Mechanical connector 1/2"
Mass (g) 435 440 460 450 470 485 555
Length (mm) 305 355 405 345 455 480 630


  CINI Sp z o.o., 41-253 CZELAD, ul.Piaskowa 31, tel./fax 032 265 30 37, 265 65 33, 269 70 37, e-mail: cini@cini.com.pl